Best IP29M Series Installationshandbuch

IP29M SERIESINTENDED FOR DOMESTIC COOKING ONLYINSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER.HOMEOWNER: USE AND CARE AND OPERATION INFORMATION ON PAGES 1

- 10 -15.INSTALL THE HOOD15.1INSTALLATION WITH DECORATIVE FLUE COVER AEIWP SERIESAssemble the hood assembly to the mounting brackets by aligning keyho

17.REINSTALL THE PANUsing a Phillips no. 2 or Robertson no. 2 screwdriver and the retaining screws, reinstall the pan(previously removed in step 6) in

- 12 -20.USE AND CAREEvolutionary™ Hybrid Baffle FiltersThe Evolutionary™ hybrid baffle filters should be cleaned frequently. Use a warm detergent sol

Always turn ON your hood before you begin cooking in order to establish an air flow in the kitchen. Let the blower run for a few minutesto clear the a

- 14 -Grease filter reset• Once the grease filter cleaning is done, press on the grease filter reset push-button (item 4 on control illustration) to r

- 15 -SERVICE PARTSKEY PART QTY (HOOD WIDTH)NO. NUMBER DESCRIPTION 42’’ 54’’1 V08069 CONTROL PROCESSOR UNIT 112 V08073 PARTICULATES SENSOR 113 V13924

- 16 -WARRANTYWARRANTYONE-YEAR LIMITED WARRANTYBroan-NuTone LLC (“Broan-NuTone”) warrants to the original consumer purchaser of its products that such

WARNING WARNING- 2 -TO REDUCE THE RISK OF FIRE, ELECTRICSHOCK OR INJURY TO PERSONS, OBSERVETHE FOLLOWING:1. Use this unit only in the manner intended

HL0091- 3 -Model 415(7” round adjustable elbow)Model 427 (41/2” x 181/2” to 10” Round, 6” high - lateralModel 423 (41/2” x 181/2” to10” Round - vertic

- 4 -HL0090- IP29M SERIES RANGE HOOD SYSTEM -IN-LINE AND EXTERIOR BLOWERSIn-line and exterior blower rough-in kit(included with EB6, EB9, EB12, EB15,I

- 5 -1. SELECT BLOWER OPTION AND INSTALLATION TYPEEither an interior or an exterior blower or in-line blower may be used with this hood. The Best by B

Remove the installation kit from inside the hood.Make sure that the following items are included:- Installation manual- Accessories including:• 3 E

Using a Phillips no. 2, remove 8 screwsretaining the pan (shaded part onillustration beside) to the hood.Remove the pan and set aside.- 7 -5. REMOVE T

- 8 -In the ceiling material, cut-out a 28¾” x 12½” max.opening over the installation location. Install two supporting studs inside the cut-out at dim

- 9 -HD0231INSTALLATION WITHDRY WALL TRIM ATDIP SERIES8. INSTALL BLOWER HOUSINGUse both screws (A) previously removed in step 4 to assemble the blower