Model CC34IQSBENGLISH...2FRANÇAIS...18ESPAÑOL... 34In U
- 10 -ATTACH CONTROL BOX1. Remove control box from side of blower box. Fig. 10.2. Insert control box into opening. Fig . 11.3. Attach control box w
- 11 -INSTALL THE HOOD CAUTION: At least two installers are recommended because of the large size and weight of this range hood.1. Hood is shipped in
- 12 -CONNECT WHITE-TO-WHITE,BLACK-TO-BLACK, GREEN-TO-GROUNDFIG. 16FIG. 17120 VACLINE INBOX MARKED “120VAC INPUT”3. From the room interior, pull down
- 13 -INSTALL THE FILTERS1. Pull down both closure panels as shown. Fig. 19 and Fig. 20.2. To install the grease filters, align rear filter tabs wit
- 14 -SERVICE PARTS KEY NO. DESCRIPTION PART NO. CAS BLOWER ASSEMBLY 06002259 506 BLDC DRIVER
- 15 -SERVICE PARTSModel CC34IQSBCAS1251244744773432509AQIIMEUS-CIRRUS BLDC64362439507506202ARU202116202115415 (03202288)415 (03202288)415 (03202288)(
- 16 -99045156BWARRANTYLimited WarrantyWarranty Period and Exclusions: Broan-NuTone LLC (the “Company”) warrants to the original consumer pur-chaser
- 2 -READ AND SAVE THESE INSTRUCTIONS WARNINGTO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:1. Use this un
- 3 -! CAUTION1. For indoor use only.2. To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air int
- 4 -OPERATIONControls (Fig. 2)The hood is operated using the (5) push-buttons located on the hood and the remote control.LED colors are displayed on
- 5 -HOODCONTROLREMOTE CONTROLThe remote control is linked to the hood at the factory.If, for some reason, the link is lost - follow the directions be
- 6 -CLEANING AND MAINTENANCEProper maintenance of the Range Hood will assure proper performance of the unit.MotorThe motor is permanently lubricated
- 7 -PREPARE THE HOODUnpack hood and check contents.You should receive: 1 - Range Hood Body 1 - Remote Control 6 - Grease Filters 2 - Screws, 4 x 9.5
- 8 -INSTALL THE DUCTWORK FIG. 6ROOF CAP48" TO 72" ABOVECOOKING SURFACEHOOD8" ROUNDDUCT8" ROUNDTO 3¼” X 14”REDUCER3¼” X 14”UNDEREA
- 9 -PREPARE THE HOOD SUPPORT1. Construct a wood framing system as shown in Fig. 9.2. The structure must be capable of support-ing its own weight, p
Kommentare zu diesen Handbüchern